Wine Guardian Humidifier Specifications download pdf (Page 30)

Reinstalling the Wires

1) Realign color coded wires.

2) Wrap each wire around the screw and tighten the screw.

Adding Additional Wiring

√ Splice onto the factory furnished wire

√ Match the wire colors for continuity

√ Insulate the splice with electrical tape on each wire

CAUTION

RISK OF DAMAGE TO EQUIPMENT

Misconnected thermostat wiring results in improper operation and/or causes damage to the

unit and thermostat. Check each colored wire to its proper color coded slot on the terminal

strip and check that the wires are tight.

Mounting the Thermostat

Each thermostat comes with its own unique manufacturer’s Installation and Operating Instructions.

Use the instructions on how to set and operate the thermostat and to understand how to install the

thermostat.

Mount the thermostat on a solid surface away from doors, corners, air outlets, drafts or heat gener-

ating equipment. Do not mount the thermostat directly on an outside wall or wall adjacent to a boiler

room. Use a piece of foam insulation behind the thermostat to insulate it from a hot or cold

surface. The recommended height is 4 feet to 5 feet above the floor.

Setting the Thermostat

The thermostat has been wired and set up in the factory for testing. It is an electronic digital

thermostat for one (1) stage cooling and one (1) stage heating. No additional adjustments should

be necessary except adjusting the cellar temperature to your preference. Note that the heating and

cooling cannot be set any closer than three degrees Fahrenheit apart to prevent short cycling. If

additional adjustments or changes are necessary, please refer to the thermostat manufacturer

literature included in the box for detailed installation and operating instructions.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 53 54

No comments

Wine Guardian Humidifier Specifications Page 30