Wine Guardian Through-the-Wall Specifications download pdf (Page 9)

Standard Specifications

IMPORTANT

Design and specifications are subject to change without notice

The Wine Guardian System Contains

√ A capillary tube expansion to control the flow of refrigerant into the evaporator coil

√ A filter dryer to keep the refrigerant clean and free of contaminants

√ Dual factory mounted plastic supply/return air grilles for evaporator and condenser air

movement

√ Movable suply air louvers for side-to-side directing of cold air into the wine cellar

√ A manually reset, high-pressure switch on the discharge to protect the compressor

from high pressures

√ Environmentally friendly R-134a refrigerant

√ An internally/externally mounted digital electronic control with many user-controlled

settings

√ Auxiliary drain port connection at condenser end of unit

All exterior framing of the Wine Guardian is powder coated, 0.063" gauge aluminum to prevent rust

and corrosion. All coils are copper tubes with aluminum fins. The evaporator is coated with an “E”

coat finish to prevent premature corrosion.The system uses an internal drain system to remove excess

moisture and not reintroduce it into the cellar or ambient space. An auxiliary drain port is located at the

condenser end of the unit should there be a need to physically remove the excessive moisture.

Each system is provided with a pre-wired and tested electronic digital thermostat (local user interface)

as standard, or an optional remote mounted thermostat (remote user interface) in the cellar. The

thermostat has multiple control functions for the fans, cooling and heating (if equipped), and maintain-

ing humidity.

Compressors are self-lubricating, permanently sealed, hermetic reciprocating type compressors, with

internal overload protection and capacitor start with a minimum of one-year manufacturers warranty

and an optional five -year warranty. Compressors are mounted on rubber-in-shear isolators to reduce

noise and vibration.

Electric power is supplied by a single, factory-furnished cord and plug that can be connected on the

cellar side or the condenser side of the system. Systems are shipped from the factory with the plug

attached on the condenser side. (to switch plug to the cellar side see page ???of this manual.) All

external controls are 24-volt supplied from an internal transformer.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 38 39

No comments

Wine Guardian Through-the-Wall Specifications Page 9