Wine Guardian Through-the-Wall Specifications download pdf (Page 29)

Installation of the Optional Wine Guardian

Remote Sensor

The Remote Sensor is a combination temperature and humidity

sensor only. It is designed to be mounted within the wine cellar

and can be used in combination with Local Interface Controller or

the Remote Interface Controller and up to two additional Remote

Sensors to control multiple areas within the wine cellar.

Mounting the Remote Sensor

Fig.1

1. Disconnect the communication cable from the back the

remote sensor. Install the communication cable within

the wall and/or ceiling structure of the wine cellar to the

desired controller mounting location.

2. Mount the Remote Sensor on a solid surface away from

doors, corners, air outlets, drafts or heat generating

equipment. Do not mount the Remote Sensor directly on

an outside wall or wall adjacent to a boiler room. Use a

piece of foam insulation behind the sensor to insulate it

from a hot or cold surface. The recommended height is

4 to 5 feet above the finished floor.

3. Remove the sensor cover plate by removing the two

allen head screws at the top of the cover using the allen

head wrench provided in the kit.(Fig.2) Mark the

mounting points at the desired location within the wine

cellar. Also mark the location of the communication

cable connection as this area will require sufficient

clearance, for instance 1½” hole in the wall for flush

mounting of the sensor plate.

Fig.1

Important

A splitter device has been supplied within the Remote

Sensor kit. The splitter device must be mounted at the

WG unit.. DO NOT mount the splitter device at the back

of the Remote Interface Controller or to the back of the

Remote Sensor as this WILL cause component or system

damage.

Fig, 2

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 46 47

No comments

Wine Guardian Through-the-Wall Specifications Page 29